Smartwatch Delta brings you a never-seen-before 3D hologram UI display, straight from your favorite science fiction movies. You can make your smartwatch match your OOTD with its 300+ watch faces. Its fully capacitive 1.3-inch touch display is built to give you maximum control. Besides recording the calories you burn, steps, and distance covered through its smart activity tracker, it also comes with "Guided Meditative Breathing" mode and the "Do Not Disturb" mode that helps you minimize stress levels and rejuvenate. You can also control your camera and music with a single click.
1.3" Full Touch LCD Display
20-65 degree Celcius
Up to 7 days, Standby 15-20 days
All Bluetooth Devices
Attach the magnetic end of the charging cable which comes with the watch package on the charging pad of the watch which is located on the back of the watch and connect the other end which is a USB-A end to a 5V, 2A rated power adapter or power bank or a computer.
The watch Delta’s display would show the charging status and charging percentage while charging.
If the watch Delta is connected to a computer USB port for charging, the speed of charging would be less as the power pushed by the USB port of a computer is less than the 5V 2A rated power adapter.
Check if the charging connector behind the watch is clean and rust free.
Try cleaning it with an alchohol swab.
If the problem still persists, kindly replace the product.
Battery charge status is shown on the watch homepage with the percentage of the charge remaining on the watch Delta’s battery.
Before using the Watch Delta for the first time, please fully charge the smartwatch first.
Charging through wall adapter – Specs of the adapter: 5V, 2A
Any other accessories could be used for charging the Watch Delta as long as the above norms are followed.
Incorrect Data Recording
Make sure you wear the watch while sleeping in order to track the sleep data.
Sleep data is estimated primarily by the movements. Once you lay down, the watch will take approximately an hour to assume that you have gone to sleep.
Check if the readings are obstructed by the user's hair, tattoo, scaring and wearing the watch too lose or too tight might affect the readings.
Check if the heart rate sensor available at the bottom of the watch is glowing in green or not. If the sensor is working properly then it should glow in green colour.
Check if the device was not subject to any mishandling, broken wires or exposed to direct sunlight or hazards like fire and liquid.
Your watch is tracking the movement of your wrist so if you are doing something that requires a lot of hand movement then step count can be affected.
Blood pressure monitoring is only for the reference, data may not match with the medical equipment. This watch is not a medical grade equipment.
Via QR Code Scanning
Find the QR code on the product manual of the Watch Delta for installing the Wearable App on the media devices of the users.
Open the QR Code Scanner app on the user’s devices and scan the code present on the user manual of the Watch Delta.
Thereafter, follow the on-screen instructions to install the Wearable app on the user’s device.
Via Searching the app on Google Play or Apple Play Store
On Google Play or Apple App Store, in the search bar, type ‘boAt Wearable App’ and enter search.
You will see the boAt Wearable app in the search result list.
Click on the install button to install boAt Wearable app on the user’s media device.
After installing the boAt Wearable app, turn the watch Delta on and open the Wearable app on the user’s device.
Click on the ‘Start Setup’ on the Wearable app to switch on the Bluetooth on the user’s device.
The previous process would enable the user to search for the Watch Delta to connect with the Wearable app as it would enable the Bluetooth of the device.
Once the Watch Delta is found via Bluetooth, it will show on the Wearable app.
Click on the ‘Delta’ Device and then click on the ‘Pair’ button to start paring Watch Delta with the boAt Wearable app.
Once the connection is successful all the fitness data stored on the Watch Delta will sync automatically on the Wearable app.
Check to see if the device with which is trying to connect Watch Delta are using Android 4.4/ iOS 8.0 or above OS version in their respective devices.
Check if users have downloaded and installed boAt Wearable app their smartphones or not. It is necessary to accept and agree to all the T&C and permissions including the location services on the device.
Make sure the Watch Delta in not directly connected with the smartphone’s Bluetooth, make sure users are connecting it via the boAt Wearable app.
Make sure the Bluetooth of users’ device is on and try to bind the watch with the boAt Wearable app. Once the device is discoverable, it will display on the app screen, click to connect the device with the app.
The operational distance for the Bluetooth is 10m. It is ideal that phone and watch is in direct contact with each other.
If still the Bluetooth is disconnecting, close the app, switch off and on the Bluetooth and start the app again.
Make sure the app is running in background always.
Yes, step counting, heart rate monitoring, calorie count, spO2, BP, time can be recorded directly on your watch while your phone is not connected.
Watch has some internal memory to record this data.
Once you are in contact with your phone, you can sync the data to the app.
Make sure call alert and message alert are enabled from the app.
Sync the watch after enabling these features
Even if the notifications are not coming, switch off your phone’s Bluetooth and again switch on OR restart your phone
Try uninstalling and installing the boAt Wearable app and then start binding process with the watch and check if the issue is still persisting or not.
Reset the watch and check if the function is working or not.
Yes, users can control music from your watch. Previous/next/volume up/Volume down can be adjusted from the watch. Users have to enable the feature from the appfirst.
In order to sync the data to the boAt Wearable app, connect the watch Delta to the media device via the Wearable app and go to the app’s homepage, drag down the screen.This will start the syncing process and data will be synced to the app.
Make sure you are in Bluetooth range and watch and Wearable app are nearby when you are syncing the data.
If the app is taking too long time to sync or it gets stuck while syncing, unbind the device with the app and reconnect again.
Note: Try to sync the data of the app at least once in every 7 days to avoid huge data to be synced in a single go and to avoid any data loss.
Relax mode is the meditative breathing mode to improve your breathing. Select time 1 min or 2 min for how long you want to do the meditation. Watch will vibrate to notify to when to inhale and when to exhale.
Yes, you have to shake your wrist to click photos or click the tick button on the screen to take photos. Make sure you open camera from the app and use shutter from the watch.
Yes. screen brightness and screen time out can be adjusted from settings option. Youcan also long press the home screen to increase the brightness.
Inside the menu, click on the ‘Blood Oxygen’ icon while wearing the watch on the wrist.
Bring your wrist close to your heart and try to hold the arm still.
This will enable the watch to show the reading of the spO2 in the blood of the user on the watch’s screen.
Bloodpressure, spO2 and Heart Rate monitoring is only for the reference, data may not match with the medical equipment. This watch is not a medical grade equipment.
Long press the button located on the right side of the Watch Delta, it would lead to turning the watch on
Raise your wrist to wake up the screen of the watch.
While the Watch Delta is ON, go to the setting option in the main menu and then tap on shut down shutdown option, this would lead to turning the watch off.
Swiping left on the Watch Delta’s home screen would lead to opening the menu.
While the user is inside the menu, tapping the several icons would lead to entering the different modes on the Watch Delta.
There are following mode options on the menu of the Watch Delta-
(i) Sport – For tracking the exercises done by the users.
(ii) Heart Rate – For measuring the heart rate of the users.
(iii) Blood Oxygen – For Measuring the saturation level of oxygen (spO2) in the user’s blood
(iv) Blood Pressure – For measuring the blood pressure of the users
(v) Relax – For breathing exercise of the users
(vi) Alarm – To set up alarm for the users
(vii) Music Control – To control the music from the watch when the users are listening to music
(vii) Timer – To set up timer for the users when in need
(viii)Settings – To enter in to the settings of the watch
There are 8 different exercises which can be tracked via Sports Mode.
(i) Walking (ii)Running (iii) Cycling (iv) Skipping
(v) Badminton (vi) Basketball (vii) Football (viii) Swimming.
Select any one of the exercises before starting that particular exercise.
Short press side button to start/pause that particular exercise
To stop that particular exercise tracking session, long press the side button.
Inside the menu, click on the ‘Blood Oxygen’ icon while wearing the watch on the wrist.
Bring your wrist close to your heart and try to hold the arm still. This will enable the watch to show the reading of the spO2 in the blood of the user on the watch’s screen.
Inside the menu, click on the ‘Relax’ icon while wearing the watch on the wrist.
Choose your preferred time for breath in and breath out and relax to undergo the breathing exercise.