1. Ensure the comb is installed until “click” sound.

2. Adjust the comb knob (1–6 mm / 7–12 mm / Body comb) properly.

3. Do not change the length during trimming.

1. Reattach the comb firmly until secure click.

2. Avoid any excessive pressure during use.

3. Inspect the comb teeth for damage.

1. Ensure the trimmer is OFF before installation.

2. Align head properly with slot.

3. Attach until it snaps into place magnetically.

4. Do not twist during installation.

1. Slight warmth during usage is normal.

2. Do not press the blade teeth against skin.

3. Allow the device to cool between long sessions.

1. Fully charge the trimmer before use (up to 120 minutes).

2. Disconnect the adapter before operating.

3. Avoid partial charging cycles repeatedly.

1. Ensure device is charged.

2. Check charging and power status on display.

3. Restart device after charging.

1. Ensure Type-C cable is firmly connected.

2. Use recommended 5V ⎓ 1A adapter.

3. Try an alternate cable/adapter.

4. Ensure the charging port is dry and clean.

5. Confirm Red LED glows.

1. Use only 5V ⎓ 1A adapter.

2. Avoid the laptop USB ports.

3. Do not use it while charging.

4. Ensure the power source is stable.

1. Select an appropriate comb (1–6 mm / 7–12 mm / Body comb).

2. Adjust as required for desired trimming length.

3. Avoid changing the settings while trimming.

• Use the device with the selected grooming head for Face, Body, or Nose & Ear trimming. It delivers precise grooming with up to 0.5 mm trimming accuracy without using a comb.

1. Use cleaning brushes to remove hair.

2. Blade, comb, and device can be rinsed with water (IPX6).

3. Dry all parts immediately after cleaning.

1. Apply 2–3 drops of light trimmer oil on the blade teeth.

2. Run the trimmer for 10 seconds to distribute oil evenly.

3. Now wipe the excess oil.

• Before storing the device, ensure that both the trimmer and the charging port are completely dry to maintain safe and optimal performance.

1. Align the selected trimmer head (T-Blade / Body / Nose-Ear) with the trimmer body.

2. Attach until it snaps into place magnetically.

3. Ensure the secure fit before use.

1. Switch OFF the device.

2. Gently pull the trimmer head upward to detach.

3. Do not twist while removing.

1. Align the comb with blade and slide into place until it “clicks”.

2. Ensure the comb is firmly attached before use.

1. Switch OFF the device.

2. Hold the comb from both sides and gently pull away from blade.

1. Fully charge the trimmer before initial use.

2. Use a 5V ⎓ 1A USB power adapter.

3. Connect the Type-C cable to the trimmer and plug into a suitable power source.

4. Digital display indicates charging and battery status.

Note: Ensure the charging port is completely dry before connecting the adapter.

1. The digital display reflects full battery status.

2. Disconnect charger after full charge.

3. It takes up to 120 minutes for the full charge.

4. Do not charge continuously for extended periods after full charge.

1. Charge the trimmer fully before first use.

2. Use a 5V ⎓ 1A USB power adapter.

Note: Unplug the adapter when the trimmer is in use.